Michael,
I’ve installed the motor into the isolation base. My particular install is a bit different since I use Rega’s turntable shelf and there isn’t a solid surface where the IB is. I took a piece of 1/8” (3mm) aluminum that is the width (almost) of the IB and ran one piece from side to side of the shelf and another running from front to back. The two piece intersect at the place where the IB sits. The washers you supplied were very helpful. I’m attaching some photos for reference.
I had read reviews of the sonic improvements resulting from separating the motor from the plinth, but I wasn’t expecting to hear what I am hearing.I’ve done a lot to my RP3, but I didn’t start modifying until after I wore out the original cartridge and started researching what cartridge I would get as a replacement. That’s when I ended up finding out about ALL the modifications that are available. I knew my RP3 very well and thought it was an excellent turntable in stock form.
I added the TT-PSU and an upgraded power supply. The subplatter, pulley, dual belts, adjustable feet, bearing housing with ceramic bearing, counterweight, tonearm and platter have all been upgraded. I’ve been able to listen to the improvement each change in parts has made. It’s a highly detailed playback machine now.
From the moment of the first needle drop with the motor in the isolation base, the clarity across the entire sonic spectrum has improved. It’s impressive and I applaud you for creating an excellently engineered product.
Best regards,
Bobby Weitzel
Bobby Weitzel
0 comments:
Post a Comment